ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area, and remove all packing materials except for the plastic ties around the upper body arms. Do not dispose of the packing materials until assembly is com-
pleted. Assembly requires your own Phillips screwdriver (_ | and rubber mallet _. |
Note: The underside of the treadmill walking belt is coated with
1.With the help of a second person, carefully raise the treadmiU to the upright position as shown. If there are plastic ties on the pulse sensors, remove them.
Insert one of the Extension Legs (55) into the treadmill as shown. Make sure that the Extension Leg is turned so the Base Pad (44) is on the bottom. If necessary, tip the Uprights (64) forward as you insert the Extension Leg.
Insert the other Extension Leg (not shown) in the same way.
Note: To prevent damage to the Upper Body Arms (2) if
they are moved too far sideways, the lower end of each2 Upper Body Arm features a breakaway connector. If one
of the Upper Body Arms breaks away, simply press the lower end back onto the Ball Joint (109, not shown).
2.With the help of a second person, carefully lower the Uprights (64) as shown. Note: It may be helpful to place your foot on one of the Wheels (58) as you tip the Uprights. Make sure that the Extension Legs (55) re- main in the Uprights.
Attach each Extension Leg (55) with an Extension Screw (35), a 1" Screw (13), and a Base Pad (44) as shown.
Note: One replacement Base Pad (44) may be included. If a Base Pad becomes wom and needs to be replaced, use the replacement Base Pad.
44
58
35
113
44
6
