4.Hold one of the Handrails (1) at an angle as shown and insert the upper end into the right Upright (11) as far as possible. Keep the lower end of the Handrail away from the treadmill to avoid scratching the finish.
Next, rotate the lower end of the Handrail (1) to the posi- tion shown by the dotted line. Note: It may be necessary to pull back on the lower end of the Handrail in order to position the Handrail against the bracket on the Extension Leg (34).
Make sure that the hole in the bracket on the Extension Leg (34) is aligned with the hole in the Handrail (1). If the holes are not aligned, rotate the Handrail away from the treadmill and slide the upper end of the Handrail slightly out of the Upright (11). Then, rotate the lower end of the Handrail back to the position shown by the dotted line. Repeat, if necessary, until the holes are aligned.
4a.Refer to drawing 4a. Make sure that the lower end of the Handrail (1) is against the bracket on the Extension Leg. Tighten an Extension Leg Screw (53) into the bracket and the Handrail.
Attach the other Handrail (not shown) as described above.
5.Attach the Storage Latch (14) to the left Upright (11) with two Latch Screws (3). Be careful not to overtighten the
Latch Screws.
6.Remove the backing from the Adhesive Clip (33). Press the Adhesive Clip onto the right Upright (11) in the indi- cated location. Press the Allen Wrench (88) into the Adhesive Clip.
7.Make sure that all parts are tightened before you use the treadmill. To protect the floor or carpet, place a mat under the treadmill.
6
4 |
|
| 11 |
| 1 |
Bracket |
|
| 34 |
4a |
|
| 53 |
| Bracket |
1 | 34 |
| |
5 |
|
| 3 |
11 | 14 |
| |
6 |
|
| 11 |
| 88 |
| 33 |
