3.Slide the upper end of a Handrail (85) into the right Upright (82) as shown. Note: It will be necessary to pivot the Handrail to the side and back repeatedly (see arrow A) while pushing on the Handrail (see arrow B) to slide it fully into the Upright. Next, pivot the lower end of the Handrail down, push it toward the right Upright, and then align it with the indicated hole.
Slide the other Handrail (85) into the left Upright (82) as described above.
4.With the help of a second person, carefully tip the Uprights (82) down as shown. Make sure that the Extension Legs (103) remain in the Uprights.
Attach each Extension Leg (103) with two Short Screws (101) as shown.
Next, tighten a Handrail Bolt (78) with a Handrail Washer
(96)into each Extension Leg (103) and Handrail (85) as shown. Note: It may be necessary to move the Handrails up or down to align the Handrails with the holes in the Extension Legs.
With the help of a second person, carefully tip the Uprights (82) back to the upright position.
3
Hole
4
828201
°°
1 0378
1o3 '"
5.Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 17), To protect the floor or carpet from damage, place a mat under the treadmill.
7
