ProForm DRTL99720 user manual Power Cord

PROBLEM: The thumb pulse sensor does not function properly

SOLUTION: a. Wash your hands before to using the pulse sensor. In addition, keep the pulse sensor clean using a damp cloth and a small amount of mild detergent.

PROBLEM: The walking belt slows when walked on

SOLUTION: a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 8.

b.If the walking belt is overtightened, treadmill perfor- mance may decrease and the walking belt may be-

come damaged. Remove the key and		UNPLUG THE
POWER CORD	. Using the allen wrench, turn both

rear roller adjustment bolts counterclockwise, 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each side of the walking belt 3 to 4 inches off the walking platform. Be careful to keep

the walking belt centered. Plug in the power cord, in- sert the key, and run the treadmill for a few minutes. Repeat until the walking belt is properly tightened.

b

3”–4”

Rear Roller Adjustment Bolts

c. If the walking belt still slows, please call our Customer Service Department, toll-free.

PROBLEM: The walking belt is off-center or slips when walked on

SOLUTION:	a. If the walking belt is off-center, first remove the key and
	UNPLUG THE POWER CORD	. If the walking belt has
	shifted to the left,	use the allen wrench to turn the left
	rear roller bolt clockwise 1/2 of a turn;		if the walking belt
	has shifted to the right,	turn the bolt counterclockwise
	1/2 of a turn. Be careful not to overtighten the walking
	belt. Plug in the power cord, insert the key, and run the
	treadmill for a few minutes. Repeat until the walking belt is
	centered.

b. If the walking belt slips when walked on, first remove the

key and UNPLUG THE POWER CORD. Using the allen wrench, turn both rear roller bolts clockwise, 1/4 of a turn.

When the walking belt is correctly tightened, you should

be able to lift each side of the walking belt 3 to 4 inches off the walking platform. Be careful to keep the walking belt centered. Plug in the power cord, insert the key, and care- fully walk on the treadmill for a few minutes. Repeat until the walking belt is properly tightened.

a

b

PROBLEM: The incline of the treadmill does not change correctly or does not change when iFIT.com

CD’s and videos are played

SOLUTION:	a. With the key in the console, press one of the Incline buttons.		While the incline is changing, re-
	move the key.	After a few seconds, re-insert the key. The treadmill will automatically rise to the
	maximum incline level and then return to the minimum level. This will recalibrate the incline.

21