ProForm DTL32940 user manual Indicated Bolt, but do not tighten the other Bolts yet

2.With the help of another person, carefully lower the Uprights (69) as shown. (Note: It may be helpful to place your foot on one of the Extension Legs [63] as you tip the Uprights.) Make sure that the Extension Legs re- main in the Uprights.

Attach each Extension Leg (63) with two 3/4” Tek Screws (58).

Attach four Base Pads (57) with four 3/4” Tek Screws

(58)as shown. Note: One replacement Base Pad may be included. If a Base Pad becomes worn and needs to be replaced, use the replacement Base Pad.

With the help of another person, carefully raise the Uprights (69) to the vertical position.

3.Attach the Storage Latch (29) to the left Upright (69) with two 1” Screws (99). Do not overtighten the Screws.

4. Identify the Right Handrail (72), which has a large hole in

the left side. Remove any ties from the bracket on the

Right Handrail and from the Wire Harness (42). Feed the

Wire Harness up into the bracket on the Right Handrail

and out of the large hole in the left side. (Note: It may be

helpful to use needlenose pliers to pull the Wire Harness

out of the large hole.) Press a Handrail Cap (76) onto the

lower end of the Right Handrail as shown.

2
57
58
58	58
		57
57	63
58
	58		69
		57	63
	58
3
	29
		99
	69
4	42
	Large
	Hole

Bracket 37 38

Insert the bracket on the Right Handrail (72) into the top

of the Right Upright (69) so that the Handrail Cap (76) is

resting against the Right Upright. Attach the Right

72

37

69

Handrail and the Handrail Cap with three 3/4” Bolts (37)

and three Washers (38) as shown. Firmly tighten the

indicated Bolt, but do not tighten the other Bolts yet.

Attach the Left Handrail (not shown) as described above.

Note: There is not a wire harness on the left side.

7

38

Tighten

38

37 76