7.Set the Console (78) on the Left and Right Uprights (9, 10). Be careful not to pinch any wires. See drawing 6 on page 8. Make sure that the Upright Wire Harness (17) is not in the small cutout shown by the arrow.
Using the included 90° screwdriver and a phillips screw- driver, attach the Console (78) to the Uprights (9, 10) and the Console Crossbar (88) with six 3/4” Screws (39).
Start all six Screws before tightening any of them; be careful not to overtighten the Screws.
8.Lower the Uprights (9, 10) until the handrails are touch- ing the floor.
See the lower drawing. Position the Uprights (9, 10) so that the treadmill Frame (12) is centered between the Uprights.
Firmly tighten the four 2 3/4” Bolts (47). Then, raise the Uprights (9, 10) back to the vertical position.
9.Remove the knob from the pin. Make sure that the collar and the spring are on the pin as shown. Insert the pin into the Latch Housing (77), and tighten the knob back onto the pin.
7 |
|
|
| 78 |
|
39 | 88 | 39 |
| ||
| 39 | |
10 |
| |
| 9 | |
|
| |
8 |
|
|
| 9, 10 |
|
47
Handrail
Top View
10 | 9 |
| 12 |
9 |
|
Knob |
|
| 77 |
| Collar |
9 | Pin |
| Spring |
10.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 24). To protect the floor or carpet, place a mat under the treadmill.
9
