8.Have a second person hold the Bridge (95) near the Right Upright (78). Remove the wire tie from the Upright Wire (38).
Connect the Upright Wire (38) to the Bridge Wire (52). See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON.
9.Insert the indicated connectors into the Right Upright (78).
Next, insert the fronts of the brackets on the Bridge (95) into the Uprights (74, 78), and then fully insert the brackets. Make sure that the plastic edges of the Bridge (95) are inside the Uprights. Be careful not to pinch the wires.
Attach the Bridge (95) with six 1/4" x 1/2" Bolts
(7) and six 1/4" Star Washers (10); start the two
Bolts indicated by the arrows first before starting the other four Bolts. Tighten all six Bolts.
See steps 5 and 7. Tighten the four 3/8" x 4 1/2" Bolts (6).
8 |
95 |
52 |
38 |
78 |
Wire Tie |
52 |
38 |
9 |
| |
| 95 | |
7 | Connectors | |
| ||
10 | 7 | |
Front | ||
| ||
| Edge | |
| 7 | |
74 | 10 | |
| ||
| 7 | |
| 78 |
9
