10. Have a second person raise and hold the tread- | 10 |
| |
mill Frame (51). | Cylinder | ||
| |||
Identify the Gas Spring (98). Note that the Gas |
| 98 | |
Spring has a cylinder end and a rod end. See | 51 | 96 | |
Rod | |||
the two small inset drawings. Locate the Spring |
|
| |
Clip (96) in the rod end of the Gas Spring. Using |
| Bracket | |
your fingernail or the end of a screwdriver, press |
| ||
|
| ||
on the end of the Spring Clip to loosen it, rotate |
|
| |
the Spring Clip, and then pull the Spring Clip out | 96 | 96 | |
of the Gas Spring. Be careful to avoid losing | |||
| |||
the Spring Clip. Note: Extra Spring Clips are in- |
|
| |
cluded. |
|
|
Next, hold the rod end of the Gas Spring (98) near the bracket in the center of the Frame (51). Press the end of the Gas Spring as far as possi- ble onto the ball on the bracket.
See the lower inset drawing. Insert the Spring | 51 |
|
Clip (96) into the two indicated small holes in the | 98 | |
rod end of the Gas Spring (98). Then, rotate the |
|
|
Spring Clip until it clips onto the Gas Spring. |
| Bracket |
|
| 96 |
| Holes | |
11. Pivot the cylinder end of the Gas Spring (98) | 11 | |
down to the position shown. Remove the Spring | ||
| ||
Clip (96) from the end of the Gas Spring. |
| |
Next, align the cylinder end of the Gas Spring |
| |
(98) with the bracket in the center of the Base | 98 | |
(52). Press the end of the Gas Spring onto the | 52 | |
ball on the bracket. Note: It may be necessary | 96 | |
| ||
to pivot the Frame (not shown) forward or back- | Bracket | |
ward slightly to align the end of the Gas Spring | ||
| ||
with the ball. |
| |
See the lower drawing. Insert the Spring Clip | 98 | |
| ||
(96) into the two indicated small holes in the |
| |
Gas Spring (98). Then, rotate the Spring Clip |
| |
until it clips onto the Gas Spring. |
| |
With the help of a second person, lower the | 52 | |
96 | ||
Frame (not shown) to the floor. | ||
Holes | ||
| ||
| Bracket |
10
