12.Attach the ground wire on the Wire Harness (39) to the indicated hole in the Base (52) with a 1/2" Ground Screw (84).
13.See the lower drawing. Position the Uprights (53, 54) so that the treadmill Frame (51) is cen- tered between the Uprights.
Firmly tighten the two M10 x 60mm Patch Bolts
(1) and the four M10 x 58mm Bolts (2). Be care- ful not to overtighten the M10 x 60mm Patch Bolts.
14.Attach the Latch Housing (48) to the Left Upright (53) with two M4.2 x 19mm Screws (10); start both Latch Screws before tightening them. Make sure that the large hole in the Latch Housing is on the indicated side.
Remove the knob from the pin. Make sure that the collar and the spring are on the pin. (Note: If there are two collars, place one on each side of the spring.) Insert the pin into the Latch Housing (48). Then, tighten the knob onto the pin.
Plug in the power cord (see OPERATION AND ADJUSTMENT on page 12). Next, change the incline of the treadmill to the lowest level as described on page 14. If this is not done, the latch may not hold the treadmill in the stor- age position.
12
52
Ground Wire 
| Hole | 39 | 84 |
|
|
| |
13 |
|
| 1 |
|
|
| 2 |
|
| 51 |
|
|
| Top View | |
54 |
| 51 | 53 |
|
|
| |
14 |
|
|
|
|
|
| 53 |
|
| 48 |
|
Knob |
|
| Spring |
10 | Collar |
Large Hole | Pin |
15.Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex keys in a secure place. The hex key is used to adjust the walking belt (see page 20). To protect the floor or carpet, place a mat under the treadmill.
11
