2.Have a second person hold the Base (52) in the position shown.
Identify the Left Upright (53) (the Right Upright [54] has a large hole near the lower end).
Hold the Left Upright (53) so the two small holes for the latch assembly are on top as shown. Insert two M10 x 58mm Bolts (2) into the bracket on the Left Upright. Attach the Left Upright to the Base (52) with the Bolts, two M10 Star Washers (9) and two M10 Jam Nuts (16).
Do not tighten the Nuts yet.
Attach the Right Upright (54) to the Base (52) in the same way.
3.Slide the two Wheel Housings (45) onto the Base (52). Attach each Wheel Housing with two M6 x 58mm Bolts (13), two M6 Washers (32), and two M6 Nuts (43).
4.Position the Base (52) as close to the front of the treadmill as possible, as shown.
See the upper inset drawing. Wrap the wire tie in the Right Upright (54) around the end of the Wire Harness (39). Then, pull the other end of the wire tie until the Wire Harness is extending from the upper end of the Right Upright. Secure the Wire Harness to the top of the Right Upright so that it will not fall inside.
See the lower inset drawing. Press the indicated Grommet (49) into the Right Upright (54).
2 |
|
|
|
| 9 |
|
|
2 |
|
|
|
54 |
| 16 |
|
|
|
| |
| 9 |
| 9 |
Large |
| 52 | 2 |
Hole |
|
| 16 |
Small Holes |
|
|
|
|
|
| 9 |
|
| 53 |
|
3 | 32 |
|
|
45 |
|
| |
43 |
| ||
|
| ||
13 | 32 |
|
|
|
|
| |
|
|
| 32 |
|
| 45 | 43 |
|
|
| |
|
| 13 | 32 |
| 52 |
| |
4 |
| 4a |
|
| 39 | 39 | 54 |
Wire Tie
54
52
4b
54
49
39
52
7
