DIAGRAM OF THE CONSOLE
Displays
Speed |
|
| On/Reset | Pulse | Incline |
Control | Clip | Key | Button | Sensor | Control |
CAUTION: Before operating the con- sole, read the following precautions.
•Do not stand on the walking belt when turning on the power.
•Always wear the clip (see the drawing above) while operating the treadmill. When the key is
BATTERY INSTALLATION |
|
|
The console requires | three “AA” batteries | (not |
included). Alkaline batteries are recommended. |
| |
To install batteries, open the battery cover under the |
| |
console as shown below. Press three batteries into the | ||
battery com- |
|
|
partment. |
|
|
Make sure |
| Battery |
that the nega- |
| |
| Cover | |
tive ends of |
| |
|
| |
the batteries |
|
|
(marked |
|
|
are touching |
|
|
the springs. |
|
|
Close the bat- |
| Batteries |
tery cover. |
| |
|
| |
removed from the console, the walking belt will stop.
•Adjust the speed in small increments.
•To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the
console and use only a sealable water bottle.
STEP BY STEP CONSOLE OPERATION
Before operating the console, make sure that the power cord is properly plugged in. (See HOW TO PLUG IN THE POWER CORD on page 7.) If there is a
thin sheet of clear plastic on the face of the console, remove it.
Next, step onto the foot rails of the treadmill. Find the clip attached to the key (see the drawing above), and slide the clip onto the waistband of your clothing.
Follow the steps on pages 9 and 10 to operate the console.
8
