5
1. With the help of a second person, carefully lay the treadmill on
its right side as shown (refer to the drawing on page 4 to iden-
tify the right side).
Insert the Extension Legs (41) into the treadmill. Make sure
that the Extension Legs are turned so the Base Pads (36) are
on the indicated side. Attach each Extension Leg with an
Extension Leg Screw (34).
With the help of a second person, carefully raise the treadmill
to the upright position so the Extension Legs (41) are resting
flat on the floor.
Refer to the inset drawing. Remove the nut, bolt, and shipping
bracket from the left Upright (14).
2. Refer to HOW TO LOWER THE TREADMILL FOR USE on
page 13. Follow the instructions in step 2 to lower the treadmill.
If there are any plastic ties in the Handrails, cut and remove
them.
Position the Left Handrail (2) on the left Upright (14). The lower
end of the Left Handrail should be on the outside of the
Extension Leg (41) as shown. Note: The Right Handrail will
have a “Right” Sticker placed on it. Thread a Handrail Bolt (15)
with a Handrail Washer (16) into the left Upright and the Left
Handrail. Do not tighten the Handrail Bolt yet.
Attach the lower end of the Left Handrail (2) to the Extension
Leg (41) with a 3 1/2” Handrail Bolt (89), a 3/8” Washer (61),
and a Flange Nut (57). Do not tighten the Handrail Bolt yet.
34
34
41
36
89 61
15
16
14
57
41
2
41
36
1
2
Handrail Washer (16)–4 Extension Leg Screw (34)–2
3 1/2" Handrail Bolt (89)–2
3/8" Washer (61)–2
Flange Nut (57)–2
1/2" Screw (13)–2
Handrail Bolt (15)–2 3/4" Screw (91)–4
Pulse Handrail Bolt (97)–2
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Refer to the drawings below to identify the small
parts used in assembly. Assembly requires the included allen wrench and your own phillips screw-
driver , adjustable wrench , open end wrench and scissors .
Bolt
14
Nut
Shipping
Bracket