ProForm PCTL53590 With the help of a second person, hold the Console Base, To each other

3.With the help of a second person, hold the Console Base

(6)and the Right Handrail (32) near the right Upright (14) as shown. Route the Console Wire Harness (92) through

the bracket on the Right Handrail.

Refer to the inset drawing. Slide the Strain Relief Clip

(88)onto the Console Wire Harness (92). Make sure that there is no slack in the Console Wire Harness between the Strain Relief Clip and the Console Base (6). Insert a 3/4” Screw (91) into the Strain Relief Clip and into the in- dicated hole in the Right Handrail (32). Tighten the Screw into the Console Base.

IMPORTANT: The Strain Relief Clip (88) must be attached as instructed.

4.With the help of a second person, hold the Pulse Handrail (8) near the right Upright (14) as shown. Route the Pulse Wires through the bracket on the Right Handrail (32).

Connect the Console Wire Harness (92) to the Upright Wire Harness (26). Connect the Pulse Wires to the Console Wire Harness (92) as shown in the inset draw- ing. Make sure that the wires with tags are connected

to each other.

Position the Pulse Handrail (8) between the Left and

Right Handrails (2, 32) as shown. Insert all wires into the right Upright (14). Insert the bracket on the Right Handrail (32) into the right Upright (14). Make sure that the wires are not pinched.

5. Using the included allen wrench, attach the Pulse

Handrail (8) to the Left and Right Handrails (2, 32) with two Pulse Handrail Bolts (97) and Handrail Washers (16).

6.Attach the Console Base (6) to the Left and Right Handrails (2, 32) with three 3/4” Screws (91).

6

3
	6
Bracket			88
32			91
		92
		14	6
			32	88
				91
				92
4
Bracket
92
32	26		Pulse	8
				2
			Wires

		14
	26
	Pulse			92
	Wires
5
97 16
32	8	2	16	97
6
		6
32	91	2
				91