4.Cut the indicated plastic tie off the Right Handrail (62). Feed the large wire tie and the Console Wire Harness (90) into the Right Handrail and out through the indicated bracket. Pull as much of the Console Wire Harness through the Right Handrail as possible. Note: It may be helpful to turn the Console over on a flat surface as you do this.

Next, rest the left side of the Console Base (46) on the Left Handrail (not shown). While a second person holds the Console Base and the Right Handrail (62) in the posi- tion shown, cut the plastic tie holding the Wire Harness

(35)in the right Upright (32).Note: Be careful not to drop the Wire Harness into the right Upright.

Next, connect the Wire Harness (35) to the Console Wire

Harness (90) (refer to the inset drawing). The latch on the

Wire Harness should snap onto the Console Wire

 

Harness. If the Wire Harnesses do not fit together eas-

ily, turn them; do not force them together.

Remove the

large wire tie from the Console Wire Harness and insert

 

the slack Wire Harness into the Right Upright (32).

 

Refer to step 3 on page 5 and attach the Right Handrail

(62)as described. Be careful to avoid damaging the wires in the Right Handrail.

5.Make sure that the Console Base (46) is on the

Handrails (60, 62). Route the Console Wire Harness

(90)up into the Console Base as shown. Insert any slack into the Right Handrail (62).

Attach the Console Base (46) to the Handrails (60, 62) with four Handrail Mounting Screws (24).

6.Refer to HOW TO FOLD THE TREADMILL FOR

STORAGE on page 11. Follow the instructions in step 2 to fold the treadmill.

Attach the lower end of the Right Handrail (62) to the right Extension Leg (59) with a Latch Screw (33). Attach the lower end of the Left Handrail (60) in the same way.

Tighten all parts used in steps 3, 4, 5 and 6.

7.Remove the backing from the Adhesive Clip (101). Press the Adhesive Clip onto the base of the right Upright (32) as shown. Press the Allen Wrench (102) into the Adhesive Clip.

8.Make sure that all parts are tightened before you

use the treadmill. To protect the floor or carpet, place

6a mat under the treadmill.

4

 

 

 

 

90

 

 

35

46

62

 

 

 

 

Plastic

 

 

Tie

 

 

 

Bracket

 

90

Plastic

 

35

Tie

Wire

 

 

Tie

 

 

 

 

32

5

46

 

62

 

 

 

24

90

24

60

6

 

 

60

 

 

33

59

62

33

 

 

59

 

 

7

 

 

 

 

32

 

 

102

 

101

 

Page 6
Image 6
ProForm PCTL62590 user manual Ily, turn them do not force them together, Tighten all parts used in steps 3, 4, 5