2.With the help of a second person, carefully raise the Uprights (84) to a vertical position.
Have the second person hold the console assembly near the Uprights (84) as shown. Look under the console as- sembly and locate the Console Wire Harness (78).
Remove the tie securing the Upright Wire Harness (77) to the right Upright (84). Next, connect the Upright Wire Harness to the Console Wire Harness (78). Make sure to connect the connectors properly (see the inset draw- ing). The connectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one connector and then try again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY BE DAM- AGED WHEN THE POWER IS TURNED ON.
3.Insert the Wire Harnesses (77, 78) down into the right Upright (84).
Set the console assembly on the Uprights (84). Be care- ful to avoid pinching the Wire Harnesses (77, 78). While a second person holds the console assembly, at- tach it with four Console Bolts (64) and four Star Washers
(8) as shown; start all four Console Bolts and then firmly tighten them.
4.Orient the Latch Housing (73) so the large hole is on the indicated side. Attach the Latch Housing to the left Upright (84) with two Screws (3); start both Screws be- fore tightening either of them.
Remove the knob from the pin. Make sure that the collar and the spring are on the pin. (Note: If there are two col- lars, place one on each side of the spring.) Next, insert the pin into the Latch Housing (73). Then, tighten the knob back onto the pin.
Plug in the power cord as described on page 10, and turn on the power as described on page 12. Note: The treadmill may automatically rise to the maximum incline level and then return to the minimum level.
2 |
| |
Console |
| |
Assembly |
| |
| 78 | |
| 77 | |
78 |
| |
| 84 | |
77 |
| |
3 |
| |
Console |
| |
Assembly |
| |
77, 78 |
| |
8 |
| |
64 | 8 | |
64 | ||
84 | ||
84 | ||
| ||
4 |
| |
| 84 | |
73 |
|
Knob 
Spring
3
Large
Hole Collar Pin
7
