11. Identify the Latch Assembly (55). Remove the |
tie from the end of the tube. Make sure that the |
sleeve has been slid over hole 1 and that the |
Latch Knob (54) is locked into hole 1. Pull on |
the sleeve to make sure that it is locked into |
place. |
11
54
Tube | Hole 1 |
12. Raise the Frame (53) to the position shown. |
Have a second person hold the Frame until |
this step is completed. |
Orient the Latch Assembly (55) so that the large |
barrel and the Latch Knob (54) are in the posi- |
tions shown. Attach the Latch Bracket (68) to the |
bracket on the Base (80) with two 3/8" x 2" Bolts |
Sleeve 
12 | 53 |
|
8
4
55
(4) and two 3/8" Nuts (8). |
Attach the upper end of the Latch Assembly (55) to the bracket on the Frame (53) with a 3/8" x 2" Bolt (4) and a 3/8" Nut (8). Note: It may be nec- essary to move the Frame back and forth to align the Latch Assembly with the bracket. Lower the Frame (53) (see HOW TO LOWER THE TREADMILL FOR USE on page 18).
54
55
Large Barrel
68
80 8
4
13.Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread- mill. Keep the included hex key in a secure place; the hex key is used to adjust the walking belt (see pages
20 and 21).
10
