8.Have a second person hold the console assem- bly near the Right Upright (72). Remove the wire
tie from the Upright Wire (78).
Connect the Upright Wire (78) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Then, insert the connectors into the Right Upright (72).
Set the console assembly on the Right Upright
(72)and the Left Upright (not shown). Attach the console assembly with four 5/16" x 1" Bolts (5) and four 5/16" Star Washers (7) (only two are shown); start all four Bolts and then tighten them.
9.Insert the Book Rack (84) into the console as- sembly; it may be helpful to rock the Book Rack up and down as you insert it. Attach the Book Rack with eight 3/4" Screws (10); start all eight
Screws and then tighten them.
See steps 5 and 7. Tighten the 3/8" x 4" Bolts
10.If necessary, press the Left Tray (86) and the Right Tray (85) into the top of the console as- sembly.
8 |
|
| |
Console | Console |
| |
Wire | Console | ||
78 | Assembly | ||
Wire | |||
7 |
|
| |
5 | 7 | 78 | |
72 | |||
5 |
| ||
| Wire Tie |
|
9 | 84 |
| Console Assembly |
|
| ||
| 10 | 10 | 10 |
10 | 86 |
|
|
Console |
|
| |
Assembly |
|
|
|
|
|
| 85 |
9
