Assembly

Before beginning assembly, carefully read the following information and instructions:

Make Things Easier for Yourself!

Everything in this manual is designed to ensure that the assembly of our products can be complet- ed successfully by anyone. However, it is impor- tant to recognize that your new equipment is a sophisticated product with many small parts and consequently, the assembly process will take time. Most people find that by setting aside plenty of time, and by deciding to make the task enjoy- able, assembly will go smoothly.

¥Assembly requires two people.

¥Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.

¥Tighten all parts as you assemble them, unless instructed to do otherwise.

¥For help identifying the small parts, use the PART IDENTIFICATION CHART on page 5.

¥As you assemble the weight bench, make sure all parts are oriented as shown in the drawings.

The following tools (not included) are required for assembly:

¥ Two (2) adjustable wrenches

¥ One (1) rubber mallet

¥ One (1) standard screwdriver

¥ One (1) phillips screwdriver

¥Lubricant, such as grease or petroleum jelly plus soapy water.

Assembly will be more convenient if you have the following tools: A socket set, a set of open-end or closed-end wrenches or a set of ratchet wrenches.

1.Before beginning assembly, make sure you have read and understand the information in the box above.

Press a 2Ó Square Inner Cap (17) into each end of the Stabilizer (20). Press a Carriage Bushing (56) into each end of the Decline Carriage (44). Slide the Decline Carriage onto the indicated end of the Frame

Slide the Frame (54) onto the bracket (A) on the Stabilizer (20) and secure it with two M10 x 65mm Bolts (5), four M10 Washers (6) and two M10 Nylon Locknuts (1). Tighten the Nylon Locknuts until there is no play between the Frame and Stabilizer.

2.Press a 2Ó Square Inner Cap (17) into each of the open ends of the Pad Upright (19).

Attach the Pad Upright (19) to the Frame (54) with two M8 x 68mm Bolts (38), the Support Plate (16) and two M8 Nylon Locknuts (13).

Attach the Decline Strut (11) to the Decline Carriage

(44)with the M10 x 75mm Bolt (72) and an M10 Nylon Locknut (1). Do not overtighten the Nylon

Locknut. You must be able to freely pivot the Decline Strut.

1

 

 

 

 

 

 

5

 

17

6

6

20

 

54

 

56

 

 

 

 

 

 

6

6

 

 

 

 

56

44

 

17

A

 

1

 

 

 

2

72

 

 

 

11

 

13

17

 

 

 

 

 

44

54

 

16

1

 

13

38

 

 

 

 

 

19

 

 

 

 

17

 

 

17

 

6

Page 6
Image 6
ProForm PFBE66080 manual Assembly, Locknut. You must be able to freely pivot the Decline Strut