23.Slide a Handle (36) onto a Handle Frame (69) and secure it by tapping a Push Nut (70) onto the end of the Handle Frame.
Repeat this procedure for the second Handle (36).
24.Press a Weight Adapter Bushing (47) into each end of the two Barbell Adapters (61).
Slide a Barbell Adapter (61) onto each end of the Barbell (74) and secure them with two M6 x 32mm Bolts (7) and two M6 Nylon Locknuts (2). Note: If you are not going to use olympic weights, you do not need to mount the Weight Adapter.
25.Make sure all parts are properly tightened before you use the weight bench. The use of all remain- ing parts will be explained in Adjusting the Weight Bench starting on page 15.
23
6970
36
70
69
36
24
74
7
61
2
47
47
Adjusting the Weight Bench
This section explains how to adjust the weight bench. See the EXERCISE GUIDELINES on page 17 for impor- tant information on how to get the most benefit from your exercise program. Also, refer to the accompanying exercise poster to see the correct form for each exercise.
Inspect and tighten all parts each time you use the weight bench. Replace any worn parts immediately. The weight bench can be cleaned with a damp cloth and a mild,
USING THE BARBELL RACKS
Before beginning an exercise, move the Safety Stops (23) to a set of holes in the Barbell Uprights (41) that is best suited for that exercise. The selected holes should repre- sent the lowest point to which you want your Barbell (74) to go during the exercise. Rotate your Barbell until the Barbell Hooks (29) disengage from the Barbell Uprights. Perform the exercise as shown in the accompanying EXERCISE GUIDE. When you have completed the exer- cise, rotate your barbell until the Barbell Hooks lock into a set of holes in the Barbell Uprights.
WARNING: Always set both safety stops at the same height. Always make sure the barbell hooks lock into holes in the Uprights at the same height. To do this, make sure your barbell is in a level position before you try to engage the barbell hooks.
41 |
29 |
31 |
74 |
23 |
14
