4.Connect the Seat Bar Wire (88) to the Handlebar Wire (87).
Slide the Handlebar (7) onto the Seat Bar (6). Attach the Handlebar with the four Handlebar Screws (51).
Make sure that the Handlebar Screws do not damage the wires.
Pull both Grips (72) towards the Handlebar (7) until they cover the Handlebar Screws (51).
5.Remove the Console Mount Screw (69) and slide the Detent Ring (73) off the shaft of the Console (5).
Insert the console wire through the indicated hole in the Seat Bar (6).
Using the included grease pack, lubricate the shaft of the Console (5). Insert the shaft into the indicated hole in the Seat Bar (6).
Slide the Detent Ring (73) onto the console shaft and line up the hole in the Detent Ring with the hole in the shaft. Secure the Console (5) with the Console Mount Screw (69) (see the inset drawing).
Plug the console wire into the Seat Bar Wire (16).
6.Attach the Seat (43) to the indicated brackets on the Seat Bar (6) with four M6 x 16mm Seat Screws (28).
Attach the Seat Cover (35) to the Seat (43), using two M4 x 38mm Screws (4) along the rear edge and an M4 x 16mm Tapping Screw (30) on each side.
6
4 |
|
|
| 7 |
|
|
| 72 |
87 | 51 |
|
| 88 |
|
51 |
| 6 |
|
| |
| 72 |
|
5 | 69 |
|
|
| |
Console |
|
|
Wire |
| 6 |
88 |
| |
|
| |
| 73 | 69 |
|
| |
Lubricate |
| 73 |
| 5 |
|
6 |
|
|
|
| 43 |
|
| 6 |
|
| 28 |
|
| 4 |
28 |
|
|
4 |
| 30 |
|
| |
30 | 35 |
|
|
|
