6.Orient the Backrest (12) so that the narrow end is over the top of the Backrest Frame (11). Attach the Backrest to the Backrest Frame with two M6 x 25mm Screws (77) and two M6 x 45mm Screws (78).
7.Slide the top of the Backrest Frame (11) under the Handlebar (10). Pivot the Backrest Frame down onto the Rail (4) so that the pin on the Backrest Frame is inserted into the hole in the Rail.
8.Attach the Foot Plate (9) to the Rail (4) with four M6 x 25mm Button Screws (57). Do not tighten the Screws yet.
9.Connect the Wire (63) to the Console (84). The connector should slide easily into the socket and snap into place. If it does not, turn the con- nector over and then insert it. IF THE CONNEC-
TOR IS NOT INSERTED PROPERLY, THE CON- SOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Push the excess Wire into the Rail (4).
Insert three “AA” batteries (not included) into the Console (84). Alkaline batteries are recommended.
Attach the Console (84) to the Rail (4) and the Foot Plate (9) with four M4 x 16mm Screws (76).
Tighten the four M6 x 25mm Screws (57) used in step 8.
10.Make sure that all parts have been properly tight- ened. The use of the remaining parts will be explained in ADJUSTMENTS, beginning on the following page.
6 |
| Narrow |
|
| |
12 |
| End |
|
| |
| 11 | 77 |
78 |
|
|
7 |
|
|
|
| 10 |
11 |
| 4 |
Hole |
|
|
8 |
| 4 |
|
| |
9 |
|
|
57 |
|
|
57 | 57 |
|
|
| |
9 |
|
|
76 | 84 |
|
|
| |
|
| 76 |
63 |
|
|
9 |
|
|
|
| 4 |
76 |
|
|
7
