ProForm PFEL05807.0 user manual Are recommended. Important If the ellipti

12.Apply a small amount of grease to a Wave Washer (93). Slide the Wave Washer onto the right side of the Pivot Axle (65). Next, slide the Right Handlebar (9) onto the Pivot Axle.

Attach the Right Handlebar (9) with an M10 x 23mm Shoulder Screw (80) and an M10 x 20mm x 2mm Washer (81).

Repeat this step to attach the Left Handlebar

(8) to the Pivot Axle (65).

12
	8	Grease
80	81	93	Grease
			93	9
		65
				81
				80

13. The Console (5) can be operated with four 1.5V	13
“D” batteries (not included); alkaline batteries
	Battery
are recommended. IMPORTANT: If the ellipti-		Batteries
	Cover
cal exerciser has been exposed to cold tem-
peratures, allow it to warm to room tempera-
ture before inserting batteries into the
Console. If you do not do this, the console
displays or other electronic components		Battery
may become damaged. Remove the two bat-		Screws
tery screws from the back of the console, and
remove the battery cover. Insert four batteries
into the Console. Orient the batteries as shown
by the markings inside the battery compartment.
Then, reattach the battery cover. Note: If it is
difficult to reattach the battery cover, remove the		5
two battery screws, loosen the two indicated
console screws a few turns, insert the lower
edge of the battery cover into the console, and
then retighten the two console screws. Then,		Battery
reattach the battery cover with the two battery
screws.		Screws
The Console (5) can also be operated with an
optional power supply instead of batteries. To
purchase a power supply, call the telephone
number on the front cover of this manual. To
avoid damaging the console, use only a	Console
manufacturer-supplied power supply. Plug
	Screws
one end of the power supply into the jack on the
console. Plug the other end of the power supply
into an appropriate outlet that is properly
installed in accordance with all local codes and
ordinances.
	11