8.Apply a small amount of grease to the axle on the left Disc Crossbar (16). Slide a Spring Spacer (63) onto the axle; make sure that the Spring Spacer is turned so the flat side is facing the elliptical crosstrainer. Next, slide the Left Rear Spring Bracket (12) on the left Pedal Spring (11) onto the axle. Slide a Spring Bracket Washer (35) onto an M10 x 27mm Patch Screw (40), and tighten the Patch Screw into the axle.
Next, hold the lower end of the left Handlebar Leg (5) inside of the Front Spring Bracket (65) on the left Pedal Spring (11). Apply grease to an M10 Bolt Set (25). Attach the Handlebar Leg to the Front Spring Bracket with the Bolt Set. Do not overtighten the Bolt Set; the Handlebar Leg must pivot freely.
Attach the right Pedal Spring (not shown) to the right side of the elliptical crosstrainer in the same way.
See step 5. Tighten the M10 x 76mm Button Bolts (7) in the Upright (2).
See step 6. Tighten the M8 x 45mm Button Bolts (50) in the Handlebar Legs (5).
8 |
|
|
| Grease | |
|
| 16 |
11 |
| 63 |
|
| 12 |
40 | 35 | 2 |
|
| 5 |
| 65 | 25 |
Grease |
| |
25 |
| 11 |
|
| |
9.Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical crosstrainer.
8
