ProForm PFEL29222 user manual Make sure, Wires and cables, Do not get, Pinched, This step

2.While another person lifts the back of the Frame (1), attach the Rear Stabilizer (9) to the Frame with two M10 x 75mm Carriage Bolts (34) and two M10 Nylon Locknuts (33).

3.The Console (23) requires three “AA” batteries (not included); alkaline batteries are recommended. Insert three batteries into the battery compartment. Make sure that the batteries are oriented as shown by the diagram inside the battery compartment.

4.While another person holds the Console (23) in the position shown, insert the control cable and the con- sole wire down through the Upright (2). Attach the ground wire to the Upright with an M4 x 16mm Screw (52). Insert the excess cable and wire into the Upright.

Attach the Console (23) to the Upright (2) with four M4 x 16mm Screws (52). Be careful to avoid pinching the cable and wires.

Make sure that the Resistance Knob (42) is turned to the lowest setting before proceeding.

5.While another person holds the Upright (2) in the posi- tion shown, connect the console wire to the Reed Switch Wire (53).

Next, connect the control cable to the Resistance Cable (43) in the following way:

•See drawing A. Pull up on the metal bracket, and insert the tip of the control cable into the wire clip on the Resistance Cable (43) as shown.

•See drawing B. Firmly pull the control cable and slide it into the metal bracket on the Resistance Cable (43) as shown.

•See drawing C. Using pliers, squeeze the prongs on the upper end of the metal bracket together.

Push the excess cable and wires down into the Frame

(1). Insert the Upright (2) into the Frame. Do not pinch the wires or cables. Secure the Upright to the Frame with two M10 x 76mm Button Bolts (7), two M10 Split Washers (45), and two M10 Nylon Locknuts (33). Do not tighten the Bolts yet.

6

2			33
			9
	33
		1
			34
3
			Batteries
23
4		23
			42
Console Wire
52
	52	Control Cable
Ground Wire
		52
	2
5	2		Make sure the
		45	wires and cables
			do not get
		7
33			pinched and
			damaged during
Control			this step.
		Console
Cable
		Wire
43		53
1
A		B	C
Metal			Control
Bracket
			Cable
Control		Control
		Cable
Cable
43		43	43