1.To make assembly easier, read the information on page 5 before you begin assembling the elliptical exerciser.
Identify the Rear Stabilizer (4). While another person lifts the rear of the Frame (1), attach the Rear Stabilizer to the Frame with two M10 x 75mm Carriage Bolts (34) and two M10 Nylon Locknuts (29).
2.See the inset drawing. Remove the two M10 x 45mm Button Bolts (33) and the packing tubes from the front of the Frame (1). Remove the rubber band from the Lower Wire Harness (87). Discard the rubber band and the packing tubes.
Attach a Wheel (32) to the Front Stabilizer (3) with an M10 x 45mm Button Bolt (33) and an M10 Nylon Locknut (29). Do not overtighten the Nylon
Locknut; the Wheel should turn freely.
Attach the other Wheel (32) to the Front Stabilizer
(3) in the same way.
Press two Stabilizer Endcaps (35) onto the Front Stabilizer (3).
1 |
|
|
|
|
|
|
|
| 29 |
|
|
| 29 | 1 |
|
|
| 4 | |
|
|
|
| |
|
|
|
| 34 |
2 | Packing |
|
|
|
| Tube |
| 87 |
|
| 33 |
|
| |
|
|
|
| |
Packing Tube |
| 1 |
| |
|
| 29 | 32 | 35 |
| 32 |
| ||
|
|
| ||
|
|
|
| |
| 33 |
|
| 3 |
| 35 |
|
| |
|
|
|
| |
6
