5.The Console (5) requires four “D” batteries (not includ- ed); alkaline batteries are recommended. IMPOR-
TANT: If the ellipical exerciser has been exposed to cold temperatures, allow it to warm to room tem- perature before inserting batteries into the Console. If you do not do this, the console dis- plays or other electronic components may become damaged. Press the tab on the battery cover and remove the battery cover. Insert four batteries into the Console as shown. Make sure that the batteries are oriented as shown by the markings on the battery cover. Reattach the battery door.
6.While another person holds the Console (5) near the Upright (2), connect the wire harness on the Console to the Upper Wire Harness (86). Insert the excess wire harness down into the Upright. Next, attach the Console to the Upright with four M4 x 16mm Screws (66). Be careful to avoid pinching the wire har- nesses.
7.Slide the Right Crank Arm (38) onto the four indicated welded bolts; make sure that the Right Crank Arm is in the indicated cutout in the Left Pedal Disc (8).
Next, finger tighten four M8 Jamnuts (101) onto the welded bolts. Then, fully tighten one of the Jamnuts, and then tighten the Jamnut farthest from the first Jamnut. Then, tighten the remaining two Jamnuts. Attach a Hub Cover (48) to the Right Crank Arm (38) with four Cover Screws (82). Then, tighten an Adjustment Knob (45) onto the right Adjustment Pin (17).
5 |
5 |
Batteries |
Battery |
Cover |
Batteries |
6 | Avoid pinching the |
| |
5 | wire harnesses |
during this step | |
86 | Wire |
Harness | |
66 | 66 |
| 2 |
7 |
|
|
|
| Welded |
|
|
| Bolts |
|
|
Cutout |
| 101 | 48 |
|
|
| |
8 | 38 | 101 | 82 |
| 17 |
| 45 |
8
