ge.com
6Clean
PDW8900 Series
The CLEAN light is illuminated when the selected cycle and enhancements are complete. The light will stay ON until a pad is pressed or the door is opened and then closed.
PDW9700 and PDW9900 Series
The CLEAN light is illuminated and a double beep will sound when the selected cycle and enhancements are complete. You may remove the dishes at any time. Note the
NOTE: To turn off the audible
NOTE: If you are not using the SmartDispense and you want to turn the LOW DETERGENT LED light off, press the ADDED HEAT pad 5 times within 3 seconds. You will hear three beeps, then the light will go off. You can turn the light back on by pressing the ADDED HEAT pad 5 times within 3 seconds.
Flashing display lights.
Status Indicator Lights | What It Means |
START/RESET | Cycle has been interrupted by pressing the START/RESET pad. Light will quit |
| flashing after the dishwasher automatically drains out the water. |
Recommended dishwasher products.
Safety Instructions
Operating Instructions
GE recommends the following products for use in its dishwashers:
■For your Manual Washer Dispenser, Cascade® and Electrasol® powder, liquid or gel automatic dishwasher detergents are approved.
■For your SmartDispense Detergent Dispenser, use only the recommended detergents listed on page 10 of this manual.
■Jet Dry® and Cascade Crystal Clear® to remove spots and prevent new film buildup on your dishes, glasses, flatware, cookware and plastic.
■Cascade® Plastic Booster™ to remove red staining inside your dishwasher that can come from some
■Only use liquid or gel automatic dishwasher detergent in the SmartDispense.
■Cerama Bryte® Stainless Steel Appliance Cleaner to clean the stainless steel panel of GE and Profile™ stainless exterior dishwashers.
■Jet Dry® Dishwasher Cleaner to help remove some hard water mineral stains that can occur in hard water conditions.
Troubleshooting Tips
Consumer Support
7