5.Orient an Upper Body Leg (6) and a Ramp Wheel (24) as shown. Apply a small amount of grease to the barrel of an M8 x 63mm Bolt Set (67). Attach the Upper Body Leg and the Ramp Wheel to the Left Pedal Arm (21) with the Bolt Set and two Wheel Covers (11).
Repeat this step for the Right Pedal Arm (not shown).
6.Apply a small amount of grease to a Crank Arm Spacer (45). Orient the Crank Arm Spacer so that the flange is on the side shown, and slide it onto the Left Crank Arm (42). Then, slide the Left Pedal Arm (21) onto the Left Crank Arm.
Apply a small amount of grease to a Large Wave Washer (20) and press it against the Left Pedal Arm (21). Then, tighten an
M8 x 25mm Patch Screw (70), with an M8 Washer (64) and a Pedal Leg Cover (23), into the end of the Left Crank Arm (42).
Repeat this step for the Right Pedal Arm and the Right Crank Arm (not shown).
5 |
|
|
6 |
|
|
24 |
|
|
11 | 67 | |
21 |
|
|
11 |
|
|
Grease |
|
|
67 |
|
|
6 |
|
|
|
| 42 |
|
| Grease |
|
| 45 |
|
| 21 |
|
| 20 |
70 | 64 | 23 |
8
