6. Orient the Left Roller Leg (12), which is marked | 6 |
with a "Left" sticker, near the left Crank Arm (36) as shown.
Apply a small amount of the included grease to both sides of a Wave Washer (98). Slide the Wave Washer onto the end of the left Crank
Arm (36). Next, slide the Left Roller Leg (12) onto the Crank Arm and set the Roller (22) on the Base (1). Attach the Left Roller Leg with an M10 x 23ram Shoulder Screw (80), an
M10 x 20mm x 1.5mm Washer (84), and a Crank Axle Cap (30).
Repeat this step to attach the Right Roller Leg (21) to the right Crank Arm (not shown}.
Identify the Left Handlebar (8), which is marked with a "Left" sticker. Insert the Left Handlebar into
one of the Handlebar Legs (11) as shown.
Attach the Left Handlebar (8) with two
M8 x 42mm Bolts (71) and two M8 Nylon
Locknuts (96). Make sure that the Nylon
Locknuts are inside the hexagonal holes.
Assemble the Right Handlebar and the other Handlebar Leg (not shown} in the same way.
98
30
84
21
8O
22
i ,i
96
Hexagonal
71
11
