8.Positionan InnerHandlebarCover(18)andan OuterHandlebarCover(19)aroundtheLeft Handlebar(8)asshownThen,pulltheLeft. HandlebarWire(108)outoftheLeftHandlebar andinsertit throughtheInnerHandlebarCover.
AttachtheInnerandOuterHandlebar
Covers(18,19)withthreeM4x 16mmSelfotapo pingScrews(79)andanM4x 13mmWasher (93).Startall
Left Handlebar Wire (108) during this step.
Repeat this step for the Right Handlebar and the Right Handlebar Wire (not shown).
Apply a generous amount of grease to the Pivot Axle (65) and insert it into the Frame (2).
Pull the Left Controller Wire (110) through the left Frame Cover (17), and then pull the Right Controller Wire (111) through the right Frame Cover.
Attach each Frame Cover (17) to the Frame (2) with two M4 x 16mm Screws (86). Avoid pinch- ing the Controller Wires (110, 111) during this step.
10.Connect the Left Handlebar Wire (108) to the Left Controller Wire (110). Insert the excess wire into the Left Handlebar (8).
Apply a small amount of grease to both sides of a Wave Washer (98). Slide the Wave Washer onto the left side of the Pivot Axle (65). Next, slide the Left Handlebar (8) onto the Pivot Axle as shown. Attach the Left Handlebar with an M10 x 23mm Shoulder Screw (80) and an
M10 x 20mm x lmm Washer (81). Avoid pinch- ing the wires during this step.
Repeat this step for the Right Handlebar (9).
8
/
/
I
/
/
/
/' / /
/ i
10
Avoid pinching the wires during this step.
81
8O..
Grease
Avoid pinching the Handlebar Wires (108, 109) during this step.
111
Avoid pinching the Controller Wires (110, 111) during this step
110
9
