![](/images/new-backgrounds/1183203/1832039x1.webp)
ASSEMBLY
To hire an authorized service technician to assemble the elliptical exerciser, call
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included hex keys, assembly requires a Phillips screwdriver , an adjustable
wrench , and a rubber mallet
.
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre- assembled. If a part is not in the hardware kit, check to see if it has been preassembled.
Star Washer | M4 x 13mm | M6 Split |
| M8 x 15mm x 4.5mm | M8 Split |
| Wave Washer | |
Washer | Washer | Washer |
| Washer | ||||
|
|
|
|
|
|
|
| M4 x 16mm |
M10 x 20mm x | M10 x 25mm |
| M8 Nylon |
| M10 Nylon |
| ||
1mm Washer | Washer | Locknut | Locknut |
| Screw | |||
|
|
|
|
|
|
|
| |
M4 x 16mm | M6 x 35mm Phillips |
| M8 x 16mm Patch | M8 x 42mm Bolt | ||||
Screw | Screw |
| Screw |
|
|
| ||
| M8 x 75mm Patch |
| M10 x 20mm Patch | M10 x 23mm Shoulder | ||||
| Screw |
|
| Screw |
| Screw | ||
M10 x 62mm Patch Bolt |
| M10 x 78mm Patch Screw | ||||||
|
|
|
| 5 |
|
|
|
|