ProForm PFEL91030 user manual Assembly

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical crosstrainer in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the

included allen wrenches, assembly requires a phillips screwdriver , an adjustable

wrench , and a rubber mallet .

Refer to the drawings below to identify the small parts needed for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST on page 22. The number following the key number is the quantity needed for assembly. Note: Some small parts may have been pre-assembled. If a part is not found in the parts bag, check to see if it has been pre-assembled.

M8 Nylon	M8 Split	M8.5 Small	M10 Washer
Locknut (46)–4	Washer (94)–10	Washer (53)–2	(99)–2
M4 x 16mm	M4 x 16mm Round	M4 x 14mm Round	M4 x 12mm Round
Screw (66)–12	Head Screw (45)–1	Head Screw (93)–2	Head Screw (18)–2
M6 x 16mm Tapered	M8 x 19mm Shoulder	M8 x 38mm Button	M8 x 43mm Button
Button Screw (107)–8	Screw (22)–2	Screw (70)–2	Bolt (50)–4
M8 x 45mm Button		M8 x 54mm Button	M10 x 35mm Carriage
Screw (102)–4		Screw (33)–4	Bolt (20)–2
		Union Bolt Set (27)–2
M4 x 52mm Screw (98)–2

1.While another person lifts the front of the Frame (1), thread a Leveling Foot (72) fully into the underside of the Frame. Next, attach the Front Stabilizer (3) to the front of the Frame with two M8 x 54mm Button Screws (33) and two M8 Split Washers (94).

1
3
	94	1
94	33	72

5