12.Attach the Backrest (13) to the Backrest Frame (8) with three M6 x 38mm Button Bolts (14) and three M6 Washers (54).
13.Identify the Left Pedal (40), which is marked with an “L.” Using an adjustable wrench,firmly tighten the Left Pedal counterclockwise into the left Crank Arm (19). Tighten the Right Pedal (not shown) clockwise into the right Crank Arm. Important: Tighten both
Pedals as firmly as possible. After using the recumbent cycle for one week, retighten the Pedals. For best performance, the Pedals must be kept tightened.
Adjust the Left Pedal Strap (41) to the desired posi- tion and press the end of the Pedal Strap onto the tab on the Left Pedal (40). Adjust the Right Pedal Strap (not shown) in the same way.
12 |
13 |
8 |
54 |
14 |
13 |
41 |
40 |
Tab |
19 |
14.Make sure that all parts are properly tightened before you use the recumbent cycle. Note: After assembly is completed, some extra parts may be left over. Place a mat beneath the recumbent cycle to protect the floor.
HOW TO OPERATE THE RECUMBENT CYCLE
HOW TO ADJUST THE RESISTANCE
HOW TO ADJUST THE PEDAL STRAPS
To increase the |
| |
resistance of the | Resistance | |
pedals, turn the | ||
Knob | ||
resistance knob | ||
| ||
clockwise; to |
| |
decrease the |
| |
resistance, turn |
| |
the knob counter- |
| |
clockwise. |
|
Important: Stop
turning the knob when turning becomes difficult, or damage may result.
To adjust the pedal straps, first pull the straps off the tabs on the pedals.
Press the straps back onto the tabs using different holes in the straps.
Strap
Tab
8
