ProForm PFEX17932 user manual

4.Slide the two Handlebar Collars (7) onto the Left Handlebar (50). Insert the Right Handlebar (51) into the Left Handlebar. Connect the Handlebar Collars, the Left Handlebar, and the Right Handlebar with two M4 x 16mm Screws (66).

Attach the Handlebar Bracket (15) to the Left and Right Handlebars (50, 51) with four M8 x 22mm Button Screws (74).

Attach the Handlebar Bracket (15) to the Upright (13) with two M8 x 39mm Button Bolts (64), two M8 Nylon Locknuts (10), and an M8 x 14mm Button Screw (49).

5.While another person holds the Console (16) in the position shown, connect the wire harness on the Console to the Upper Wire Harness (36). Insert the excess wire harness into the Upright (13).

Attach the Console (16) to the Upright (13) with four M4 x 16mm Screws (66). Be careful to avoid pinch- ing the wire harnesses.

6.The Console (16) requires four “D” batteries (not included); alkaline batteries are recommended. Remove the indicated screw from the battery drawer, and pull the battery drawer open. Insert four batteries into the battery drawer; make sure that the batteries are oriented as shown by the markings inside the battery drawer. Close the battery drawer and reattach the screw. Note: When the batteries are installed cor- rectly, the fan will turn on for a moment.

7.Turn the indicated Adjustment Knob (28) counterclock- wise two or three turns to loosen it. Next, pull the Knob, insert the Seat Post (5) into the Frame (1), and then release the Knob. Move the Seat Post up and down slightly until the pin on the Knob snaps into one of the holes in the Seat Post. Then, turn the Knob clock- wise until it is tight.

7

4
	7
	66	51
10	15
	49
		74
		7
74		13
50	66
		64
5
		16
	36
66
66
		Wire
		Harness
13
6
	16
		Batteries
		Battery
Screw		Drawer
7
	5
	1
		28