ProForm PFEX25122 Handlebars are on the correct sides, Onto each end of the Handlebar Axle

8. Slide the Left and Right Handlebars (7, 9) onto the

Handlebar Axle (33). Make sure that the

Handlebars are on the correct sides.

Using the included pedal tool, tap a Push Nut (78)
onto each end of the Handlebar Axle (33).			Make
sure that	the Push Nuts are turned as shown in
the inset	drawing.	(Note: It may be helpful if anoth-

er person holds a block of wood against one end of the Handlebar Axle while you tap a Push Nut onto the other end.) Then, tap a Large Axle Cap (49) onto each end of the Handlebar Axle.

9.Identify the Left Link Arm (15), which is marked with a sticker.

Apply a small amount of grease to an M8 x 77mm

Button Bolt (58). Insert the Button Bolt into the Left Handlebar Base (8). Slide an M8 Flat Washer (73),

a Link Arm Bushing (45), the Left Link Arm (15), and

another		M8 Washer (73)		onto the Button Bolt.	Make
sure	that the Link Arm		Bushing and the Left
Link	Arm	are turned as	shown.		Tighten an M8

Nylon Locknut (66) onto the Button Bolt. Rest the notch in the Left Link Arm on the left lock rod.

Attach the Right Link Arm (not shown) to the Right Handlebar Base (not shown) in the same way.

10.Remove the 1/2” Pedal Nut (68) from the shaft of one of the Pedals (23). Make sure that there is a Pedal Spring (42), a Red Washer (71), a Pedal Bushing (43), a Black Pedal Washer (79), and a Pedal Spacer (44) on the shaft of the Pedal. In addi- tion, make sure that the Pedal Bushing (43) is turned as shown. Firmly tighten the shaft of the Pedal clockwise into the left Crank Arm (26).

Tighten the 1/2” Pedal Nut (68) back onto the shaft.

Attach the other Pedal (not shown) in the same way.

8		9
	1
			49
	33
7
78
49
	Pedal Tool	78	33
9
	66
8	73
73	45	15
58
Grease
Lock	Notch
Rod
10
	26
	68
42	44
	79
71	43
23

11.Make sure that all parts are properly tightened before you use the exercise cycle. Place a mat beneath the exercise cycle to protect the floor.

8