
DRAINING THE PUMPS | REPLACING THE LED LIGHT |
After the hydrotherapy spa is drained, the jet pumps should also be drained if the spa will be stored for more than thirty days or if it may be exposed to freez- ing temperatures.
If the underwater light burns out, you will need to remove the access panel to replace it (see ATTACHING AND REMOVING THE ACCESS PANEL on page 17). Make sure the spa power is turned off. Next, locate the light housing. Turn the light housing counterclockwise
Turn off the power to the spa. To drain the jet pumps, remove the
and remove it from the spa shell.
access panel from the spa (see ATTACHING AND REMOVING THE ACCESS PANEL on page 17). Locate the jet pumps inside the spa. Loosen the indicated collar on each of the pumps.
Light Housing
LED
Light
Light Housing
WINTER USE AND CARE
The hydrotherapy spa is designed for
1.Make sure the power to the spa is turned off.
2.Drain the spa (see DRAINING THE HYDROTHER- APY SPA on page 17).
3.Remove all remaining water from the spa shell. Dry the spa shell with towels.
4.Set the air controls to the lowest setting. Use a wet/dry vacuum to pull any remaining water from the system. To do this, place the vacuum nozzle over each jet, starting with the highest jet and fin- ishing with the lowest jet.
5.Set the air controls to the highest setting and repeat step 3.
6.Drain the pumps (see DRAINING THE PUMPS on this page). Once the water is drained from the pumps, place the vacuum nozzle over the drainage hole in the pumps and vacuum any additional water from the pumps. Note: For additional pro- tection, remove the pumps/motors from the spa and store them in a
7.Clean the spa shell (see page 15).
8.Clean the filter (see page 15).
9.Shut the power off at the breaker. Label the breaker in such a way that the breaker will not be turned on accidentally.
10.
To replace the LED light, pull the old LED light out of the housing and insert a new LED light.
18