3.Insert the pillow (47) into the lounge seat recepta- cle. The pillow can be rotated 180º to change between the high or low positions.
3 | 47 |
|
4. The hydrotherapy spa operates on a 240 volt power source and must be wired directly to a 240 volt Ground | |||
Fault Circuit Interrupter (GFCI) installed in your home. This procedure must be performed by a qualified, | |||
licensed electrician. A wiring diagram is found on the inside of the electronics package for reference. | |||
Under no circumstances should the spa be wired by someone other than a qualified electrician. Before | |||
you have the spa wired, make sure it is in the desired position, and that it can be easily serviced, if needed. | |||
5. Make sure that a qualified electrician has wired the | 5 |
| 3 |
spa to a 240 volt power source. |
| ||
|
| 22 | |
|
| Fill to here | |
Remove the two warning decals (see page 5) from |
| 21 | |
|
| ||
the spa shell. Using a damp cloth, wipe the spa shell |
|
| 16 |
clean. Before filling the spa, make sure that it is |
|
| |
|
|
| |
in the desired position and that there is room to |
|
| 5 |
easily service it. Once the spa is filled, it will |
|
| |
|
|
| |
have to be drained before it can be moved. |
|
|
|
Insert a garden hose into the filter housing, and |
|
|
|
begin filling the spa. Do not use soft water. The |
|
|
|
spa may be filled with cold water; however, if warm |
|
|
|
or hot water is used, the spa will be ready for use |
|
|
|
sooner. Fill the spa until the water is at the level of |
| Garden |
|
the molded fill line. Do not overfill the spa. |
| Hose |
|
Refer to the inset drawing. Set the Filter (5), Filter |
|
|
|
Plug (16), Diverter (21), and Basket (22) into the fil- |
|
|
|
ter housing. Next, screw the Filter Cover (3) into the |
|
|
|
filter housing until it is fully seated. |
|
|
|
6. Pull down one of the straps on the Spa Cover (11) | 6 |
|
|
and hold the Buckle (26) against one of the panels |
|
| |
|
| Strap | |
on the spa. (Note: To position the Buckle correctly, |
| 11 | |
|
| ||
have a second person hold the strap on the opposite |
|
| Latch |
side of the Spa Cover snug.) The Spa Cover must |
|
| |
|
|
| |
be snug. Do not place the Buckle over the |
|
| 26 |
grooves between the premium cedar panels. |
|
| |
|
|
| |
Refer to the inset drawing. Remove the latch from |
|
|
|
the Buckle (26). Attach the Buckle to the panel with |
|
|
|
two #4 x 3/4” Screws (27). |
|
| 27 |
|
|
| |
Attach the other three Buckles (26) to the panels in |
|
| Strap |
the same way. |
|
| |
|
|
| |
Remove the Spa Cover (11) from the spa. |
|
| 26 |
|
|
| |
9
