38.Wrap the Weight Cable (72) around a 3 1/2” Pulley (24). Attach the Pulley and a Cable Trap (25) between the lowest holes in the Adjustable Pulley Plates (23) hanging from the Ab Cable (47) with a 3/8” x 2” Bolt (54) and a 3/8” Nylon Locknut (50).
Be sure that the Cable Trap is turned to hold the Cable in place.
39.Remove the preassembled 3/8” x 1 3/4” Bolts (57) from the Small Pulley Plates (22).
Wrap the Weight Cable (72) around a 3 1/2” Pulley (24). Attach the Pulley between two Small Pulley Plates (22) with a 3/8” x 1 3/4” Bolt (57) and a 3/8” Nylon Locknut (50).
40.Wrap the Weight Cable (72) around a 4 1/2” Pulley
(82)in the direction shown. Attach the Pulley to the bracket on the Press Top Frame (9) with a 3/8” x 2” Bolt (54) and a 3/8” Nylon Locknut (50).
41.Place a 1/2” Washer (11) on top of the Weight Tube (17).
Thread a 1/2” Plain Nut (100) halfway onto the bolt on the Weight Cable (72). Screw the bolt on the Weight Cable into the Weight Tube (17) a couple of turns.
Tighten the 1/2” Plain Nut (100) down onto the 1/2” Washer (11).
38 | 47 |
| |
54 | 23 |
| |
25 | 50 |
| |
24 |
|
| 72 |
39 |
|
24 | 72 |
| |
50 | 57 |
| 22 |
40 |
|
54 | 72 |
| |
82 | 50 |
| |
9 | Bracket |
| |
41 |
|
72 |
|
100 |
|
11 |
|
17 |
|
16
