To stop the walking belt, press the Stop button.
The elapsed time will begin to flash in the
Time/Distance display.
Note: During the first few minutes that the treadmill is used, inspect the alignment of the walking belt, and align it if necessary (see page 16).
3Change the incline of the treadmill as desired.
To change the incline of the treadmill, press either of the Incline buttons until the desired incline level is reached.
4 Follow your progress with the three displays.
Time/Distance
display
and the distance that you have walked or run. The display will change
from one number to the
other every few seconds, as shown by the mode
indicators. When the Stop button is pressed, the | |||
elapsed time will flash. | |||
Fat Calories/Calories/ |
| ||
| |||
Pulse display |
|
| |
display shows the ap- |
| ||
proximate numbers of |
|
| |
fat calories | and | calories |
|
| |||
you have burned (see
FAT BURNING on page 17). The display will change from one number to the other every few seconds, as shown by the mode indicators. The display will also show your heart rate when you use the pulse sensor (see step 5).
Speed display —This
display shows the speed of the walking belt
Note: The console can
display speed and dis- tance in either miles or kilometers. To change the unit of measure-
ment, hold down the
Stop button, insert the key into the console, and continue to hold the Stop button for a moment. An
“E” for English miles or an “M” for metric kilometers will appear in the Fat Calories/Calories/Pulse dis- play. Press the Speed increase button to change
the unit of measurement. When the desired unit of
measurement is selected, remove the key and then reinsert it.
To reset the displays, press the Stop button, re- move the key, and then reinsert the key.
5 Measure your heart rate if desired.
To measure your heart rate, stand on the foot rails and place your thumb
on the pulse sensor.
Do not press too hard, or the circu- lation in your
thumb will be restricted and your pulse will not
be detected. After a few seconds, the heart- shaped indicator in the Fat Calories/Calories/
Pulse display will begin to flash, one or two dashes (–
If the displayed heart rate appears to be too high
or too low, or if your heart rate is not displayed, lift your thumb off the pulse sensor for a few seconds. Then, place your thumb on the pulse sensor as de-
scribed above. Remem ber to stand still while mea- suring your heart rate.
6 Whenkey. you are finished exercising, remove the
Step onto the foot rails, press the Stop button, and remove the key from the console. Keep the key in a secure place.
HOW TO USE THE HAND WEIGHTS
To exercise your upper body as you walk on the treadmill, hold the
or | ights. The hand weights can be stored in |
the weight rack. |
|
WARNING: Do not use the hand weights at speeds faster than walking speeds. Using weights and not holding the handrails may compromise your ability to maintain your balance. Exercises using weights should be attempted only by experienced users.
12
