ProForm PFTL31330, 325i Assembly, Adjustable wrench Wire cutters, Until instructed to do so

ASSEMBLY

Assembly requires two persons.Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrenches		and your own phillips screwdriver		,
adjustable wrench	, wire cutters		, and needlenose pliers	.

For help identifying the assembly hardware, refer to the PART IDENTIFICATION CHART below. Note: The assembly hardware and other small parts are packaged in separate part bags. Do not open the part bags

until instructed to do so.

1” Tek Screw (37)–4	1/2” Silver Screw	3/4” Screw (2)–15	Crossbar Screw
	(49)–2		(39)–2
1” Bolt (63)–4	2” Bolt (114)–4	1/4” Star
			5/16” Star
		Washer (76)–4
			Washer (48)–4
Wheel Bolt (64)–2
		1/4” Washer
3” Bolt (61)–4		(38)–4	Wheel Nut (13)–2

1. Make sure that the power cord is unplugged.		1
				64
				86
		66		69
				57
			37	57
		13
With the help of a second person, carefully tip the tread-
mill onto its left side as shown. Partially fold the Frame
(86) so that the treadmill is more stable.		Do not fully		37
fold the treadmill until it is completely assembled.
Open part bag A.	Attach four Base Pads (57) to the bot-
tom of the Base (69) with four 1” Tek Screws (37) (three
are shown).			37
Attach a Wheel (66) to the inner side of the Base (69) with				57
a Wheel Bolt (64) and a Nut (13) as shown.		Do not over-
tighten the Nut.	The Wheel should be able to spin freely.

6