5.Hold one of the Handrails (18) near the Right Upright (36). Insert the Wire Harness (28) into the hole in the bottom of the Handrail and out of the hole in the top as shown. Remove the tie from the Wire Harness.
Set the Handrail (18) on the Right Upright (36), and tighten two Handrail Bolts (20) with two Handrail Star Washers (19) into the Handrail and the Right Upright.
Make sure that the Wire Harness (28) does not get pinched.
Attach the other Handrail (18) to the Left Upright (31) as described above. Note: There is not a wire on the left side.
6. Hold the Console Base (26) near the right Handrail (18). |
Attach the end of the ground wire on the Console Base |
to the indicated small hole in the Handrail with a Silver |
Ground Screw (27). |
Connect the Wire Harness (28) to wire harness on the |
Console Base (26). Make sure to connect the connec- |
tors properly (see the inset drawing). The connectors |
should slide together easily and snap into place. If |
the connectors do not slide together easily and snap into |
place, turn one connector and try again. IF THE CON- |
NECTORS ARE NOT CONNECTED PROPERLY, THE |
CONSOLE MAY BE DAMAGED WHEN THE POWER |
IS TURNED ON. |
7. Set the console assembly on the Handrails (18); insert |
the excess wiring down into the right Handrail. Attach the |
console assembly with four 3/4” Screws (2) and two |
5 |
|
20 | 18 |
| |
19 | 28 |
| 31 |
| 20 |
| 19 |
| 18 |
| 36 |
6 |
26 |
27 |
Ground |
Wire |
28 |
18 |
28 |
7 |
Console Assembly
Console Bolts (22) with two 1/4” Star Washers (21). |
Make sure that no wires are pinched. Start all four |
Screws and both Console Bolts before tightening |
any of them. |
18
18
| 21 | 2 | |
2 | 22 | ||
21 | |||
|
| ||
|
| 22 |
8
