5.Hold one of the Handrails (18) near the Right Upright (36). Insert the Wire Harness (28) into the hole in the bottom of the Handrail and out of the hole in the top as shown. Remove the tie from the Wire Harness.
Set the Handrail (18) on the Right Upright (36), and tighten two Handrail Bolts (20) with two Handrail Star Washers (19) into the Handrail and the Right Upright.
Make sure that the Wire Harness (28) does not get pinched.
Attach the other Handrail (18) to the Left Upright (31) as described above. Note: There is not a wire harness on the left side.
6.Hold the Console Base (26) near the right Handrail (18). Attach the end of the ground wire on the Console Base to the indicated small hole in the Handrail with a Silver Ground Screw (27).
Connect the Wire Harness (28) to wire harness on the Console Base (26). Make sure to connect the connec- tors properly (see the inset drawing). The connectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one connector and try again. IF THE CON-
NECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON.
7.Set the console assembly on the Handrails (18); insert the excess wiring down into the right Handrail. Attach the console assembly with four 3/4” Screws (2), two Console Bolts (22), and two 1/4” Star Washers (21) as shown.
Make sure that no wires are pinched. Start all four Screws and both Console Bolts before tightening any of them.
5 |
|
20 | 18 |
| |
19 | 28 |
| 31 |
| 20 |
| 19 |
| 18 |
| 36 |
6 |
26 |
27 |
Ground |
Wire |
28 |
18 |
28 |
7 |
| Console Assembly | |
|
| ||
18 |
| 18 | |
|
| ||
| 21 | 2 | |
2 | 22 | ||
21 | |||
|
| ||
|
| 22 |
8
