9.Attach the console assembly to the Uprights (53, 54). Start all six M8 x 15mm Bolts (8) with six M8 Star Washers (5) into the Uprights.
Then, firmly tighten all six Bolts.
10.Attach the Latch Housing (48) and the Latch Housing Spacer (109) to the Left Upright (53) with two #10 x 1" Tek Screws (112); start both
Tek Screws before tightening either of them. Make sure that the large hole in the Latch Housing is on the indicated side.
Locate the Latch Pin Assembly (24). Remove the knob from the pin. Make sure that the collar and the spring are on the pin. (Note: If there are two collars, place one on each side of the spring.) Insert the pin into the Latch Housing (48). Then, tighten the knob onto the pin.
9 |
|
| Console |
|
|
| |
5 | 8 |
| Assembly |
|
| ||
|
|
| |
| 5 | 8 | 5 8 |
| 53 | 5 | |
|
|
| 54 |
10 |
|
|
|
| 24 |
| 53 |
| 48 |
| |
Knob112 |
| 109 | |
| Collar | ||
| Large Hole | Spring | Pin |
|
| ||
11
