ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires a rubber mallet

and a phillips screwdriver (not included).

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

1.With the help of a second person, carefully raise the Uprights (114) until the treadmill is in the position shown.

2.Using a rubber mallet, tap the Lock Knob Sleeve (91) into the large hole in the left Upright (114). Align the two small pins on the Lock Knob Spacer (122) with the small holes in the left side of the Upright. Insert the Lock Knob Spacer into the Upright. Make sure that the Lock Knob Sleeve and the Lock Knob Spacer are fully inserted into the Upright.

Remove the Lock Knob (90) from the Lock Pin (94). Make sure that the Lock Pin Collar (93) and the Spring

(92)are on the Lock Pin. Insert the Lock Pin into the left Upright (114) and tighten the Lock Knob onto it.

3.Observe the two Rear Feet (72) at the rear of the tread- mill (see figure 1 above). If there is a space between one of the Feet and the floor, the Foot Spacer (127) will need to be attached.

Hold the treadmill firmly with both hands, and raise the treadmill to the storage position as described on page 12.

Using a phillips screwdriver, remove the Screw (71) and the Rear Foot (72) from the side that was raised off the floor. Snap the Rear Foot Spacer (127) onto the Rear Foot. Reattach the Rear Foot to the treadmill Frame (79).

Hold the treadmill firmly with both hands, and lower the treadmill as described on page 13.

1

 

 

 

 

 

114

 

 

72

 

 

2

 

 

 

114

 

 

 

90

91

92

94

 

 

 

122

 

93

 

 

 

3

 

 

 

 

 

 

Ridges

79

 

 

 

 

 

 

72

 

 

 

71

 

 

127

 

4.Make sure that all parts of the treadmill are tightened before you use the treadmill. Keep the included

allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 15). To protect

6the floor or carpet from damage, place a mat under the treadmill.

Page 6
Image 6
ProForm PFTL59290 user manual Assembly, A phillips screwdriver not included