Weider PRO 9400 user manual Cable Assembly

CABLE ASSEMBLY

29.Attach the end of the Low Cable (23) to the Long ÒUÓ-Bracket (57) with a 1/4Ó Nylon Locknut (2) and a 1/4Ó Flat Washer (10).

You may need to lift the Top Weight (not shown) on the High Cable to get enough slack to attach the Low Cable to the Long ÒUÓ-Bracket.

Do not completely tighten the Nylon Locknut (2). It should be threaded onto the end of the Cable so only a couple of threads are showing above the Nylon Locknut, as shown in the inset drawing.

30.Locate the Military Press Cable (72). Attach the Military Press Cable to the other Small ÒUÓ-Bracket (71) with a 1/4Ó Nylon Locknut (2) and a 1/4Ó Flat Washer (10). Do not com- pletely tighten the Nylon Locknut. It should be threaded onto the end of the Cable only a couple of turns, as shown in the inset drawing.

Attach the Small ÒUÓ-Bracket (71) to the indi- cated Weight Tube (63) with a 5/16Ó x 1 3/4Ó Bolt (24) and a 5/16Ó Nylon Locknut (3).

31.Wrap the Military Press Cable (72) around a

3 1/2Ó Pulley (15). Attach the Pulley to the Top Frame (55) with a 3/8Ó x 2Ó Bolt (12) and a 3/8Ó Nylon Locknut (21).

See the inset drawing. Wrap the Military Press Cable (72) around a 3 1/2Ó Pulley (15). Attach the Pulley and a Cable Trap (66) to the bracket on the Stabilizer (5) with a 3/8Ó x 2Ó Bolt (12) and a 3/8Ó Nylon Locknut (21). Be sure that the Cable Trap is turned to hold the Cable in place.

15

29
		57
		2
	2	10
	10	23
23	57
30		72
	3
		71
		24
	63
	72	10
71
		2
	10
	2
31
	55
15
21		12
		72
		72
		12
		Bracket
		66
		15
		21
		5