25. Locate the Low Cable (23) and the bag |
labeled ÒLOW PULLEY.Ó Route the Low |
Cable under the 3 1/2Ó Low Pulley (76). |
Attach the Pulley and the 5/8Ó x 9/16Ó Spacer |
(7) to the Press Frame (17) with a 3/8Ó x 3 |
3/4Ó Bolt (88), 3/8Ó Flat Washer (9), and a 3/8Ó |
Nylon Locknut (21). Be sure that the parts |
are oriented as shown in the drawing, and |
that the end of the Cable with the ball is on |
the indicated side of the Press Frame |
between the Pulley and the crossbar. |
25 |
76
Ball
2317 Crossbar
88
9
7
1776
21
ASSEMBLY
26. Route the Low Cable (23) around a 3 1/2Ó |
Pulley (15). Attach Pulley and a Cable Trap |
(66) to the lower hole in the Front Upright (42) |
with a 3/8Ó x 3 3/4Ó Bolt (88), a 3/8Ó Flat |
Washer (9), and a 3/8Ó Nylon Locknut (21). |
See the inset drawing. Be sure that the |
Cable Trap is turned to hold the Cable in |
place and that the Cable is routed around |
the Pulley as shown. |
26
42
66 21
15
23
88 9
23 15
21
66
42
Inset shows view
from other side
CABLE
27.Route the Low Cable (23) around a 3 1/2Ó Pulley (15). Attach the Pulley and a Cable Trap (66) to the upper hole in the Press Frame (17) with a 3/8Ó x 3 1/2Ó Bolt (16), a 3/8Ó Flat Washer (9), and a 3/8Ó Nylon Locknut (21). Be sure that the Cable Trap is turned to hold the Cable in place and that the Cable is routed around the Pulley as shown.
27
23 9
16
15
17
21 66
28.Route the Low Cable (23) around another 3 1/2Ó Pulley (15). Attach the Pulley and a Cable Trap (66) to the upper hole in the Front Upright (42) with a 3/8Ó x 3 3/4Ó Bolt (88), a 3/8Ó Flat Washer (9), and a 3/8Ó Nylon Locknut (21). See the inset drawing. Be sure that the Cable Trap is turned to hold the Cable in place and that the Cable is routed around the Pulley as shown.
28
42
23
66 21
15
23 15
88
66
42
Inset shows view
from other side
88
9
14
