SuperSwap Manual
with two matching sets of numbered stickers. Place one sticker on the front of the drive housing assembly and the matching numbered sticker on the front of the drive carrier.
Access Cover
Power
Connector
Drive Cable
Connector
Drive Carrier
Locking Tab
Pivoting Handle
Figure 2-3: Drive Carrier Assembly
LED Messages
This section provides information on how to interpret LED display codes as reported by the SuperSwap3 when connected to the Promise SuperTrak66. Two LEDs appear on the front of the SuperSwap housing assembly: Power/Drive Status LED (left) and disk activity LED (right).
Power/Drive Status LED
Display | Means |
Green* | Drive is OK |
Amber (orange) | Drive is rebuilding and array is in “critical” mode |
Red | Drive is bad or has failed and is now “offline”; array |
| may also have failed depending on RAID level |
Black (dark) | No drive detected or no power to drive housing |
*Indicates only Power On when SuperSwap is not connected to a Promise SuperTrak66 card.
Disk Activity LED
3Note: Users must obtain and install Promise FastTrak Driver v.1.30 or later in order to implement LED display functions for the SuperSwap enclosure. Go to www.promise.com to obtain these drivers.
8
