Displaying a video image
Remove the lens cap. | remove lens cap |
|
Press the power switch to position “1” on the back of the projector, then | press Power switch | press Power button | 2 |
| |||
|
|
| |
press the Power button on the top of the projector. | I |
|
|
| O |
|
|
The LED flashes green and the fans start to run. When the lamp comes on, |
|
|
|
the startup screen is displayed and the LED is steady green. It can take a |
|
| 1 |
minute for the image to achieve full brightness. |
|
|
|
? No startup screen? Get help on page 16.
Plug in and turn on the video device. | turn on video device |
The video device’s image should appear on the projection screen. If it doesn’t, press the Video button on the keypad.
Adjust the height of the projector by pressing the release button to extend
the elevator foot. Rotate the leveling foot, if necessary. | adjust height |
|
elevator 
foot 
rotate leveling foot
Position the projector the desired distance from the screen at a 90 degree
angle to the screen. See page 42 for a table listing screen sizes and distances adjust distance to the screen.
14
