PSB Speakers manual CW260 - 6.5” Surround Speaker System, Installation Notes

CW260 - 6.5” Surround Speaker System

•Highly diffuse radiation for best surround effect

•Switchable between Bipole and Dipole radiation patterns

•Three Driver, 2-way system with special wide range fl at power response 2” units and 6 1⁄2” fi berglass textured polypropylene woofer

•Performance Enclosure and new construction bracket available

•Bipole/Dipole and Treble level switches allow for response adjustments

Frequency Range (-6dB):	50-21,000Hz
Recommended Power:	20-100 Watts
Impedance (Nominal):	8 Ohms (3.5 Ohm min. in Dipole)
Sensitivity (2.83V @1m)	87dB SPL
Drivers:	6-1/2” Woofer
	dual 2” wide range units
Overall Dimensions (W x H x D):	9-1/2 x 15-3/8 x 3-1/2”
Cut-out Dimensions (W x H):	8-1/2 x 14-3/8”

9-1/2" 241mm

8-1/2" 216mm

15-3/8" 389mm

14-3/8" 364mm

3-1/2" 89mm

Installation Notes

•Bipole surround systems work well when mounted high on the wall.

•For best Dipole response the system should be placed near ear level on side walls, perpendicular to prime listening areas.

•If the system is placed with its long dimension horizontal (or in some ceiling applications) the dual array should be unscrewed and repositioned by 90 degrees.

•Make small exploratory hole and check for obstructions in wall cavity before cutting mounting hole.

•Mounting template provided.

•Lightly fi ll wall cavity with fi berglass 2 feet above and below system. Use standard 4”

fiberglass split to half thickness. Use 1” thick

fiberglass behind system.

•Adjust electric screwdrivers to appropriate torque. Tighten mounting screws fi rmly but do not over tighten!

•Set Dipole/Bipole switch to appropriate position

•Set Treble switch to positive (+) position if listening position is distant from speakers. Set Treble switch to negative (-) position if listening position is close to speakers.

•See manual for more installation hints.

To Reach US Customer Service dial 1 888 772 0000 ext 4445 or 4342

PSB Speakers reserves the right to change specifications or features without notice. © 2006 PSB Speakers, a division of Lenbrook Industries Limited.

PSB is a registered trademark of Lenbrook Industries Limited. Printed in Canada 08/06. All rights reserved.

No part of this publication may be reproduced, stored or transmitted in any form whatsoever without the written permission of PSB Speakers 873 CW260 data.

w w w. p s b s p e a k e r s . c o m

1 8 8 8 7 7 2 0 0 0 0

CW260_data.indd 2 8/11/06 9:26:02 AM