PSC Scanners 6

6User’s / Programming Guide

NO Enable AutoSense®

NN Disable AutoSense®

To use this mode of operation properly, the user must first attach the

plastic scanner holder to the bracket of the stand as shown in

Figure 1. The (NO) Enable AutoSense® programming symbol is

scanned until the green “Good Decode” light blinks. This will acti-

vate the trigger screen. The scanner is then placed into the holder and

the user must check that the red laser beam is aimed at the reflective

label affixed to the stand. The AutoSense® is now ready to read labels

presented to it.

Figure 1. The PSC AutoSense® Stand

a. Riser sub-assembly d. Reflective tape

b. Scanner holder e. Stand base

c. Scanner

Contents

Main Page NOTICE i Table of Contents 06656 ii iii 06656 1 Introduction Keyboard Wedge Mode Serial Communications Mode AutoSense Mode Wand Emulation Mode Unpacking Keyboard Wedge Cable Installation 06656 3 Connecting the Power Supply Connecting a Magnetic Stripe Reader Terminal Power-Up Sequence 4 Serial Communications Serial TTL Mode Serial RS232 Mode 06656 5 AutoSense Operation 6 06656 7 Wand Emulation Operation 8 Setup Overview Wedge Mode Options Wand Emulation Options 06656 9 Serial Communication and Wedge Options 10 Symbologies 06656 11 Parameters Selection Guidelines Examples 12 06656 13 Serial Communication Reset Default Baud Rate 14 Page 16 Communications Protocol Table 3. 8 Bit, No Parity 06656 17 18 06656 19 Label Buffering No Read Option 20 Menu Commands Parameter Messages External Trigger Operation 06656 21 General Parameters Intercharacter Delay 22 Transmission Mode System Status 06656 23 Power Consumption Laser Redundancy 24 Laser Timeout Beeper Operation 06656 25 Message Formatting Prefixes and Suffixes 26 Prefix Suffix 06656 27 28 Code Identifier Table 4. Code Identifier Characters 06656 29 Preamble or Postamble Selection Preamble Postamble Page 06656 31 Serial Commands General Serial Command Format ACK/NAK 32 Beeper Off CR-LF Ack Command Function 06656 33 Power Standby and Serial Commands Communication Parameter Changes Manual Scanning Interaction 34 Keyboard Wedge Parameters 06656 35 36 06656 37 38 Symbologies UPC (A and E) 06656 39 40 06656 41 42 EAN/JAN 06656 43 44 Code 39 06656 45 46 Code 2 of 5 Interleaved Page 48 Code 128 06656 49 50 MSI/Plessey Code 11 06656 51 Code 93 Page Page 54 Symbology Identifiers 06656 55 56 Page Wand Emulation Parameters Page 60 Data Synchronization Page 62 Memory Module Page 64 Marker Beam 06656 65 66 Scanner Labeling Service and Warranty 06656 67 Maintenance Cleaning Inspection Page 06656 69 Appendix A 70 06656 71 72 Primary Function Key Table 06656 73 Secondary Function Key Tables 74 Secondary Function Key Tables 06656 75 76 DECLARATION OF CONFORMITY SOY INK